Getting Started; Wall Mounting - Oregon Scientific RMR686P User Manual

indicator will show up on the indoor or outdoor temperature display.
HOW TO USE THE TABLE STAND OR

WALL MOUNTING

You can place the remote unit on a flat surface or mount the unit on
a wall using the recessed screw hole.
Wall-mount

GETTING STARTED

Once batteries are in place for the remote unit, they will start
transmitting temperature readings at 78-second intervals.
The main unit will also start searching for signals for about four
minutes once batteries are installed. Upon successful reception,
the outdoor and indoor temperature will be displayed. The main
unit will automatically update its readings at about 78-second in-
tervals.
Table Stand
If no signals are received, blanks "
kinetic wave icon will show "
simultaneously to enforce another search for about 4 minutes. This
is useful in synchronizing the transmission and reception of the
remote and main units.
HOW TO CHECK REMOTE AND INDOOR
TEMPERATURES
The kinetic wave display on the outdoor temperature indicates if
the reception of the remote unit is in good order.
If no readings are received from the remote unit
be displayed until further readings are successfully searched.
if the remote unit is secure.
] and [ ] simultaneously to enforce an immediate search.
If the temperature goes above or below than the temperature
measuring range of the main unit or the remote unit (stated in
specification), the display will show "HHH" or "LLL" respectively.
HOW TO READ THE KINETIC WAVE
DISPLAY
The kinetic wave display shows the signal receiving status of the
4
" will be displayed and the
". Press [ ] and [
, blanks "
You can wait for a little while or press [
]
" will
Check