Installation Instructions - Cadet RCP502S Owner's Manual

Hide thumbs Also See for RCP502S:

Owner's manual (8 pages)

Owner's manual (13 pages)

Owner's manual (9 pages)

Table Of Contents

Table of Contents

Available languages

1. WARNING: Risk of fire. Do not use as a

residential or household heater.

2. Do not use outdoors.

3. This heater is not intended for use in bathrooms,

laundry areas, and similar indoor locations.

4. CAUTION:

Do not operate

attached.

The Hot One may sit on a floor surface or be mounted to the wall using the universal stand provided. If mounted on the

wall, maintain 6 inch minimum clearance from the top of the unit to the ceiling. The Hot One is not recommended for

ceiling mount. Recommended for elevations under 7500 feet.

STEP 1

Heater Inspection and Assembly

Thoroughly inspect your heater for any shipping or handling damage and remove any paper or packaging material found around the

heater.

Grounding Plug and Receptacle Requirements

STEP 2

This heater is for use on 240 volts. The cord has a 20 amp or 30 amp plug as shown in Figure 1. No adapter is available for these blade

configurations, and none should be used. The RCP requires a 240 volt grounded receptacle. When properly installed, it provides a

ground connection through the cord to the heater to protect the operator from electric shock. Do not use an extension cord, power strip

or any kind of adapter.

RCP502S - 30 Amp

Plug Configuration

Receptacle Configuration

NEMA #6-30R

Assembly

STEP 3

The universal stand is assembled as follows:

Floor Stand Assembly

1. Place steel washer, then rubber washer on each knob shaft

provided.

2. Screw each knob into the bracket found on both sides of the

heater, but do not tighten.

3. With heater sitting on a firm surface, slide the stand onto each

knob shaft between the steel and rubber washers (See Figure 2).

4. Tighten knobs.

Note: The heater must be operated with the stand attached to the

heater.

Wall Mount Assembly

1. Place steel washer, then rubber washer on each knob shaft

provided.

2. Screw each knob into the bracket found on both sides of the

heater, but do not tighten.

3. Mount stand to wall. The wall and mounting hardware must

be of adequate strength to support the heater. Note: A 240-volt

receptacle must be within six feet of the heater.

4. Slide the stand onto each knob shaft between the steel and

rubber washers (Figure 2).

5. Tighten knobs.