Advertisement
INSTALLATION INSTRUCTIONS
1. CAUTION – High Temperature.
Keep electrical cords, drapes,
and other furnishings away from
heater.
2. To reduce the risk of fire, do not
store or use gasoline or other
flammable vapors and liquids in
the vicinity of the heater.
1. Remove the heater and all items from the carton. Your heater is completely assembled except for
the feet which snap in place. Carefully place the heater face down to attach the feet.
longer part to
front of heater
2. For correct balance, the part of the foot with the longest length from the plastic clip to the end goes
to the front, and the part with the notch goes to the back (see Figure 1).
3. Attach the feet to the bottoms of the end caps by pushing the feet up and then slightly backward
until they snap in place (see Figure 2).
4. Stand your heater up on its feet before using.
Your SoftHeat portable heater is 120 volts, and it comes with a cord that has a grounded, 3-prong
plug. See Figure 3.
If you only have a 2-prong receptacle in your home, for safety reasons you must use a grounding
plug adapter. The green grounding lug extending from the adapter must be connected to a permanent
ground, such as a properly grounded outlet box. See Figure 4.
The adapter isn't necessary if you have a 3-slot grounded receptacle.
notched part to
back of heater
Figure 1
Figure
3
3
3. Maintain at least 12 inches (30.5
cm) minimum clearance from
all objects above and in front of
baseboard, and 6 inches (15.2 cm)
minimum on both sides.
4. Do not operate without the feet
attached.
ASSEMBLY
GROUNDING
Figure 2
grounding lug
Figure
4
Advertisement
