Installation Instructions - Cadet THE HOT ONE Owner's Manual

INSTALLATION INSTRUCTIONS

1. WARNING: Risk of fire. Do not
use as a residential or household
heater.
2. Do not use outdoors.
3. This heater is not intended for use
in bathrooms, laundry areas, and
similar indoor locations.
4. CAUTION: Do not operate without
stand attached.
GROUNDING PLUG AND RECEPTACLE REQUIREMENTS
This heater is for use with 240 volts. The cord has a 20 amp or 30 amp plug
as shown in Figure 1. No adapter is available for these blade configurations,
and none should be used. The Hot One requires a 240 volt grounded
receptacle. When properly installed, it provides a ground connection through
the cord to the heater to protect the operator from electric shock. Do not use
an extension cord, power strip or any kind of adapter.
RCP502S - 30 Amp
Plug Configuration
Receptacle Configuration
NEMA #6-30R
Unanswered questions? Call our technical support team in Vancouver,
Washington at 855.CADET.US or outside the US at 360.693.2505.
3
RCP402S - 20 Amp
Plug Configuration
Receptacle Configuration
NEMA #6-20R
PARTS OF YOUR HEATER
8-1/4"
20.9 cm
17-1/2"
44.5 cm
5. Heater must be kept clear of
all obstructions: 3 foot (92 cm)
minimum clearance from front, 6
inch (16 cm) minimum clearance
from back and top, and 12 inch
(30.5 cm) minimum clearance
from sides. See Figure 2.
6. Always plug the heater directly
into a 240 volt wall receptacle.
Never use an extension cord.
Thermostat Power
Knob Indicator
Light
Figure 1
Manual Reset
Limit Button