Assembly Of Rails, Tables, And Fences; To Install Front And Back Rail; To Install Miter Table And Fence - Craftsman 315.228110 Owner's Manual

WARNING:
Do not connect to power supply
until assembly is complete. Failure to comply
could result in accidental starting and possible
serious injury.
B. ASSEMBLY OF RAILS, TABLES, AND
FENCES
TO INSTALL FRONT AND BACK RAILS
Position end caps on both rails and secure in place
by tapping with a block of wood or a rubber mallet.
Loosen the front rail clamps one-half (1/2) turn
from the tightened position. Loosen the square rail
holder nut one-fourth (1/4) turn to allow the front
rail to slide over it. See Figures 11 and 12.
Mount the front rail with the scale facing the
outside toward the operator.
Check to make sure the rail clamps will securely
clamp the rail before sliding the entire assembly
into position. If not, repeat steps 2 and 3 above.
Slide the rail into position over both clamps and
secure.
Mount the rear rail, following the same clamping
procedure as shown for the front rail. Orient the
rear rail as shown in figure 12.

TO INSTALL MITER TABLE AND FENCE

Install the sliding miter table assembly over the
front and rear rails. See Figure 13. Check that it
slides easily on the rails. Push both front miter
locking clamps down evenly on each side to
secure. Repeat for both rear miter locking clamps.
Note: Do not force miter locking clamps fully
down. Tighten only to flat "seated" position.
To install the miter fence holder to the miter fence,
loosen the attachment bolt by turning the adjusting
clamp (the knob on top) counterclockwise. Make
sure the adjusting clamp is loose enough so the
bolt has enough clearance to slide in the table slot.
Slide the tabs into the grooves in the miter fence.
See Figure 14.
Mount the miter fence to the miter table by install-
ing the locator pin (below the miter fence) into hole
"A" or "B". (Hole "A" is closest to the blade). At the
same time, place the attachment bolt in the slot.
Secure the adjusting clamp, but do not tighten.
Note: Hole "A" should be used for short pieces of
wood and hole "B" should be used for long pieces
of wood.
Adjust the miter indicator to the scale.
Retighten the adjusting clamp.
® TABLE SAW 315.228110
ASSEMBLY
HANDWHEEL
FRONT
RAIL CLAMP
RAIL
HOLDER NUT
REAR
RAIL
18
END CAP
FRONT RAIL
LOCKING
LEVER
BLADE
ADJUSTING HANDLE
END CAP
SCALE
Figure 11
REAR RAIL
Figure 12
MITER
TABLE BASE
Figure 13