To Adjust Quick Stop; Sliding Miter Table Assembly - Craftsman 315.228110 Owner's Manual

TO ADJUST QUICK-STOP
The quick-stop is preset at the factory to stop the
miter fence at exactly zero degrees. However, when
sliding miter table adjustments are made, these
adjustments may cause the quick stop to need
adjusting. Check quick-stop with miter scale set at
zero degrees. If adjustments are needed, proceed
with the following steps:
Loosen the eccentric screw holding the quick-stop.
Place the quick-stop against the miter fence with
miter scale set at zero degrees. See Figure 60.
Adjust eccentric screw until it holds quick-stop
securely against miter fence.
Retighten hex nut, securing eccentric screw and
quick-stop.
Check your work. If the quick-stop is not at zero
degrees, repeat steps 1-4.

SLIDING MITER TABLE ASSEMBLY

Checks and Adjustments
MITER INDICATOR
MITER FENCE
ZERO
DEGREE
MITER
FENCE
QUICK STOP AND
ECCENTRIC SCREW
41
ADJUSTING CLAMP
Figure 60
® TABLE SAW 315.228110