Call Screening; Number Of Rings - AT&T CL82450 User Manual

Telephone settings
Answering system settings

Call screening

Use this feature to choose whether incoming messages can be heard over
the telephone base speaker when they are being recorded. If you turn call
screening on, you hear the incoming message. While monitoring an incoming
message, you can answer the call by pressing
on the handset.
To change the setting:
1. When the handset is in idle mode, press MENU/
enter the main menu.
2. Press qCID or pDIR to scroll to >Answering sys, then
/SELECT.
press
MENU
3. Press qCID or pDIR to scroll to >Ans sys setup, then
/SELECT.
press
MENU
4. Press qCID or pDIR to scroll to >Call screening, then
press /SELECT.
MENU
5. Press qCID or pDIR to choose On or Off.
/SELECT to confirm your setting. You hear a
6. Press
MENU
confirmation tone. Press
NOTE: For more information on call screening, see page 41.

Number of rings

You can set the answering system to answer an incoming call after two, four
or six rings. You can also select toll saver, which is explained on the next page.
Unless you change it, the answering system answers an incoming call after
four rings.
To set the number of rings:
1. When the handset is in idle mode, press MENU/
enter the main menu.
2. Press qCID or pDIR to scroll to >Answering sys, then
/SELECT.
press
MENU
3. Press qCID or pDIR to scroll to >Ans sys setup, then press
/SELECT.
MENU
4. Press qCID or pDIR to scroll to ># of rings, then press
/SELECT.
MENU
5. Press qCID or pDIR to scroll and choose among 2, 4, 6 or Toll saver.
OFF/
to cancel.
CLEAR
18
PHONE/ or
FLASH
to
SELECT
to
SELECT
/SPEA�ER SPEA�ER
Play messages
Answering sys
>
Ans sys setup
>
-End of list-
Call screening
>
# of rings
CALL SCREENING
>On
# of rings
>
Remote code
# OF RINGS
>2