Canon iPF600 series Service Manual page 136

Chapter 3
(24) Close the ink tank lock lever until it clicks. Check that the Ink lamp is light in red.
(25) Repeat steps (20) to (24) to install all ink tanks.
(26) Close the ink tank cover.
(27) When the printhead and all ink tanks have been installed, the message "Do Not Open Cover" appears on the display and initial ink filling requires about 14
minutes.
MEMO:
- Initial ink filling performed at printer installation consumes ink beween the ink tanks and printhead.
- "80%" may be displayed as the remaining ink level immediately after initial ink filling. This is not a failure.
3-8
F-3-29
F-3-30