(2) Take out the printer and accessories from the shipping box and remove cushioning materials.
First remove the cushioning materials at top of the printer. Next, remove the cushioning materials by raising the left and right sides of the printer one after another
with your hand inserted in the clearance as indicated in the figure [1].
(3) Grasaping the carrying handles [1] on the left and right side of the bottom, place the printer on a level place such as a table.
(4) The Roll Feed Unit [1] is preinstalled on the printer. Peel away the tape and remove the Roll Holder [2] and protective material from the Roll Feed Unit. Also
remove the tape on the two Holder Stoppers [3] attached to the Roll Holder, and then remove the Holder Stoppers from the Roll Holder.
(5) Remove all cushioning materials and tape from the printer and accessories.