MIC IP starlight 7000 HD, MIC IP
dynamic 7000 HD
6. Reinsert the screws into both yoke arms. Note the letter assigned to each screw in the
figure below. You will tighten the screws in a specific sequence that references each letter.
Figure 11.5: Reinsert yoke arm screws (ABCD)
7. Using a torque wrench (user-supplied), tighten the screws to the proper torque using the
sequence described in the table below.
8. Recheck all four screws to ensure the proper torque value.
Torque requirements for yoke arm screws
A
B
A
A
C
A
B
Bosch Security Systems
B
A
C
D
B
B
D
C
D
C
D
C
D
SN ≤ xxxxxxx46028xxxxxx
(≤ Dec. 2014)
T30/T27 Torx
≈ 7.5 N m
(≈ 5.5 ft lb)
≈ 15 N m
(≈ 11 ft lb)
≈ 15 N m
(≈ 11 ft lb)
≈ 15 N m
(≈ 11 ft lb)
Installation Manual
Cant the Camera | en
SN ≥ xxxxxxx46029xxxxxx
(> Dec. 2014)
5 mm Hex
(T30 Torx)
≈ 7.5 N m
(≈ 5.5 ft lb)
≈ 17 N m
(≈ 12.5 ft lb)
≈ 17 N m
(≈ 12.5 ft lb)
≈ 17 N m
(≈ 12.5 ft lb)
2015.12 | 3.0 | F.01U.291.520
25