Table of Contents
Advertisement
MIC IP starlight 7000 HD, MIC IP
dynamic 7000 HD
10
Make Connections - Power and Control
10.1
About Camera Power and Control
The camera transmits PTZ control commands and images over a TCP/IP network. It also allows
users to configure the camera display settings, camera operating settings, and to configure
the network parameters.
The camera incorporates a network video server in the IP module. The primary function of the
server is to encode video and control data for transmission over a TCP/IP network. With its H.
264 encoding, it is ideally suited for IP communication and for remote access to digital video
recorders and multiplexers. The use of existing networks means that integration with CCTV
systems or local networks can be achieved quickly and easily. Video images from a single
camera can be simultaneously received on several receivers.
10.2
Power Source Options
The camera can be powered by a network compliant to High Power-over-Ethernet (Bosch's
version of High PoE) using a Bosch model of High PoE Midspans (sold separately). With this
configuration, only a single (Cat5e/Cat6e) cable connection is required to view, to power, and
to control the camera.
The camera can also accept a standard 24 VAC power source if a High PoE network interface
will not be used. User-supplied wiring must be in compliance with electrical codes (Class 2
power levels).
For maximum reliability, the camera can be connected simultaneously to a High PoE Midspan
and a separate 24 VAC power source. If High PoE and 24 VAC are applied simultaneously, the
camera usually selects auxiliary input (24 VAC) and will draw minimal power from the High
PoE Midspan. If the 24 VAC power source fails, the camera switches power input seamlessly
to High PoE. After the 24 VAC power source is restored, the camera switches power input
again to 24 VAC.
Warning!
Bosch's version of High PoE:
!
If supplying power to the camera by HPoE or a midspan device, you must install additional
surge protection.
In the table below, an "X" identifies the power source options for MIC7000 camera models.
CAMERA MODELS
Models with illuminator
Models without
illuminator
The table below identifies the power devices that can be connected simultaneously to the
camera.
60 W midspan (NPD-6001A)
95 W midspan (NPD-9501A)
VIDEOJET connect (VJC-7000-90)
Bosch Security Systems
60 W midspan
95 W midspan
X
If power is supplied from:
Installation Manual
Make Connections - Power and Control | en
VIDEOJET connect
X
X
X
X
Camera can receive power simultaneously from:
(VG4-A-PSU1, VG4-A-PSU2)
24 VAC PSU
X
X
24 VAC PSU
2015.12 | 3.0 | F.01U.291.520
17
Advertisement
Table of Contents
