Jenn-Air 720-0720 Installation Instructions And Use & Care Manual page 10

6. Attach the side shelf to the control panel (C) by tightening the
screw from the side shelf control panel to the main control
panel.
A
C
7. Remove the 3 screws from the searing side burner.
8. Remove the searing side burrner.
9. Remove the 2 screws from the side burner valve assembly
(A).
10. Push the valve stem out through the opening in the front of the
side burner shelf, lining up the holes in the side burner valve
assembly with the openings on the side burner shelf.
11. Attach the side burner valve assembly to the side burner shelf
with the screws removed in Step 9 (A).
10
12. Replace the searing side burner, angling it so that the side
burner tube slides over the valve orifice (B).
B
A
13. Connect electrical plugs on underside of sear burner.
A
A. Electrical plug from grill
B. Electrical plug from sear burner
14. To install the searing side burner knob, locate the opening on
the underside of the knob behind the rubber grip. Slowly peel
back the rubber grip.
15. Insert an Allen wrench into the hole and into the setscrew.
Insert the valve stem into the knob and tighten the setscrew.
16. The igniter battery is not factory installed. A "AA" size alkaline
battery is located in the accessory box on the grill grate. Install
battery at this time following the instructions in "Replacing the
Igniter Battery" section.
B
B