Pfaff 1571 Instruction Manual page 71

The second seam section should have
- the knee switch function at the end of the seam section
- and a 2.4 mm stitch length (for roller presser and feed wheel).
PM
2
2
By pressing the corresponding +/- key set the stitch length for the roller presser
at "2.4 ".
By pressing the corresponding +/- key set the stitch length for the feed wheel at "2.4".
Sew the second seam section manually.
PM
2
2
After the machine has stopped the seam section end must be entered.
By pressing the knee switch or the F3 key, switch on the end of section with knee
switch function.
By pressing "+" on the corresponding +/- key change to the third seam section.
The third seam section should have
- the thread trimming function at the end of the seam section
- a 2.8 mm stitch length (for roller presser and feed wheel).
PM
3
3
By pressing the corresponding +/- key set the stitch length for the roller presser
at "2.8 ".
By pressing the corresponding +/- key set the stitch length for the feed wheel at "2.8".
2.4 2.4
END
1 NO
2.8 2.8
Input
11 - 18