Removing The Power Trim And Tilt/Hydro Tilt - Yamaha FT50C Service Manual

Removing the power trim and
tilt/hydro tilt
1. Fully tilt the outboard motor up, and then
support it with the tilt stop lever 1.
WARNING
After tilting up the outboard motor, be
sure to support it with the tilt stop lever.
Otherwise, the outboard motor could sud-
denly lower if the power trim and tilt unit
should lose fluid pressure.
2. Loosen the plastic locking tie 2, and
then pull out the PTT motor lead 3.
3. Remove the tilt pin 4.
4. Remove the circlip(s) 5 and the shaft 6.
5. Loosen the bolt 7, and then remove the
shaft 8.
6. Remove the power trim and tilt/hydro tilt
9.
62Y5A11
Power trim and tilt unit
NOTE:
To remove the power trim and tilt/hydro tilt,
lower the tilt rod slightly.
1
2
3
4
5
6
7
8
9
7-26