Detaching And Refitting The Cleaning Blade - Kyocera Mita KM-1505 Service Manual

(4) Detaching and refitting the cleaning blade

Follow the procedure below to replace the cleaning blade.
Prucedure
1. Remove the image formation unit (see page
1-6-27).
2. Remove the main charger unit (see page 1-6-
28).
3. Remove the drum (see page 1-6-29).
4. Remove the two screws and remove the
cleaning blade.
5. Replace the cleaning blade and refit all the
removed parts.
• Apply toner or white powder to the edge of
the new cleaning blade.
• After fitting the cleaning blade, slide it to the
right and left once and check that the right
and left edges of the blade do not ride over
or enter under the seal.
• Rotate the drum shaft in the direction of the
arrow marked on the image formation unit
frame and check that the cleaning blade
does not flip up.
Cleaning blade
Figure 1-6-51
Cleaning blade
Figure 1-6-52
2BT
1-6-31