Care And Cleaning - Zanussi ZDT15002 User Manual

1. Adjust the water softener to the lowest level.
2. Set the rinse aid dispenser to the lowest position.
If you stop to use the combi detergent tablets, before you
start to use separately detergent, rinse aid and dishwasher
salt, do these steps:
1. Press the on/off button to activate the appliance.
2. Set the water softener to the highest level.
3. Make sure that the salt container and the rinse aid
dispenser are full.
4. Start the shortest programme with a rinsing phase,
without detergent and without dishes.
5. Adjust the water softener to the water hardness in
your area.
6. Adjust the released quantity of rinse aid.
Setting and starting a programme
Setting mode
The appliance must be in setting mode to accept some
operations.
The appliance is in setting mode when, after the activa-
tion:
• All the programme indicators come on.
If the control panel shows other conditions, press and
hold function buttons (B) and (C) at the same time until
the appliance is in setting mode.
Starting a programme without delay start
1. Open the water tap.
2. Press the on/off button to activate the appliance.
Make sure that the appliance is in setting mode.
3. Press the button of the programme you want to set.
• The related programme indicator stays on.
• All the other programme indicators go off.
4. Close the appliance door. The programme starts.
Starting a programme with delay start
1. Set the programme.
2. Press the delay button again and again until the indi-
cator of the number of hours you want to set comes
on. You can set 3, 6 or 9 hours.

Care and cleaning

Warning!
• The delay indicator comes on.
3. Close the appliance door. The countdown starts.
When the countdown is completed, the programme
starts.
Opening the door while the appliance operates
If you open the door, the appliance stops. When you close
the door, the appliance continues from the point of inter-
ruption.
Cancelling the delay start
Press and hold function buttons (B) and (C) at the same
time until the delay indicator goes off and all the pro-
gramme indicators come on.
When you cancel a delay start, the appliance goes
back to setting mode. You have to set the pro-
gramme again.
Cancelling the programme
Press and hold function buttons (B) and (C) at the same
time until all the programme indicators come on.
Make sure that there is detergent in the detergent
dispenser before you start a new programme.
At the end of the programme
When the programme is completed, an intermittent acous-
tic signal operates.
1. Open the appliance door. The end indicator is on.
2. Press the on/off button to deactivate the appliance.
3. Close the water tap.
• For better drying results, keep the appliance door ajar
for some minutes.
• Let the dishes become cold before you remove them
from the appliance. Hot dishes can be easily damaged.
• First remove the items from the lower basket, then from
the upper basket.
There can be water on the sides and on the door of
the appliance. Stainless steel becomes cool more
quickly than the dishes.
Before maintenance, deactivate the appliance and discon-
nect the mains plug from the mains socket.
9