Care And Cleaning - Zanussi ZDT 16011 User Manual

Make sure that there is detergent in the detergent
dispenser before you start a new programme.
At the end of the programme
When the programme is completed, an intermittent acous-
tic signal operates.
1. Open the appliance door.
• The display shows 0.
2. Press the on/off button to deactivate the appliance.
3. Close the water tap.
If you do not press the on/off button, the AUTO OFF
device automatically deactivates the appliance after

Care and cleaning

Warning!
Before maintenance, deactivate the appliance and discon-
nect the mains plug from the mains socket.
Dirty filters and clogged spray arms decrease the
washing results.
Make a check regularly and, if necessary, clean them.
Cleaning the filters
1
C
B
A
2
some minutes. This helps to decrease the energy con-
sumption.
• For better drying results, keep the appliance door ajar
for some minutes.
• Let the dishes become cold before you remove them
from the appliance. Hot dishes can be easily damaged.
• First remove the items from the lower basket, then from
the upper basket.
There can be water on the sides and on the door of
the appliance. Stainless steel becomes cool more
quickly than the dishes.
3
To remove filters (B) and
(C), turn the handle coun-
terclockwise and remove.
Pull apart filter (B) and
(C). Wash the filters with
water.
D
A
5
Put filter (A) to its initial
position. Make sure that it
assembles correctly under
the two guides (D).
An incorrect position of the filters can cause bad
washing results and damage to the appliance.
A
4
Remove filter (A). Wash
the filter with water.
6
Assemble filters (B) and
(C). Put them into position
in filter (A). Turn the han-
dle clockwise until it
locks.
23