Troubleshooting - Zanussi ZDT15002 User Manual

Dirty filters and clogged spray arms decrease the
washing results.
Make a check regularly and, if necessary, clean them.
Cleaning the filters
1
3
To remove filters (B) and
(C), turn the handle coun-
terclockwise and remove.
Pull apart filter (B) and
(C). Wash the filters with
water.

Troubleshooting

The appliance does not start or it stops during operation.
First try to find a solution to the problem (refer to the ta-
ble). If not, contact the Service.
Alarm code
• The indicator of the set programme flashes continu-
ously.
• The end indicator flashes 1 time intermittently.
• The indicator of the set programme flashes continu-
ously.
• The end indicator flashes 2 times intermittently.
10
C
B
A
2
A
4
Remove filter (A). Wash
the filter with water.
D
A
5
Put filter (A) to its initial
position. Make sure that it
assembles correctly under
the two guides (D).
An incorrect position of the filters can cause bad
washing results and damage to the appliance.
Cleaning the spray arms
Do not remove the spray arms.
If the holes in the spray arms are clogged, remove remain-
ing parts of soil with a thin pointed object.
External cleaning
Clean the appliance with a moist soft cloth.
Only use neutral detergents. Do not use abrasive prod-
ucts, abrasive cleaning pads or solvents.
With some problems, some indicators flash continuously
and/or intermittently at the same time to show an alarm
code.
The appliance does not fill with water.
The appliance does not drain the water.
6
Assemble filters (B) and
(C). Put them into position
in filter (A). Turn the han-
dle clockwise until it
locks.
Problem