Zanussi ZDT15002 User Manual page 11

Alarm code
• The indicator of the set programme flashes continu-
ously.
• The end indicator flashes 3 times intermittently.
Warning! Deactivate the appliance before you make
the checks.
Problem
The programme does not
start.
The appliance does not fill
with water.
The appliance does not drain
the water.
After the checks are completed, activate the appliance. The
programme continues from the point of interruption.
The washing results and drying results are not satisfactory
Problem
The dishes are not clean.
Possible cause
The mains plug is not connected in the
mains socket.
The appliance door is open.
The fuse in the fuse box is damaged.
The delay start is set.
The water tap is closed.
The water pressure is too low.
The water tap is clogged or there is lime-
scale on it.
The filter in the water inlet hose is clog-
ged.
The water inlet hose has a kink or a
bend.
The anti-flood device is on. There are
water leakages in the appliance.
The sink spigot is clogged.
The water drain hose has a kink or a
bend.
Possible cause
The filters are clogged.
The filters are not correctly assembled
and installed.
The anti-flood device is on.
Connect the mains plug.
Close the appliance door.
Replace the fuse.
Cancel the delay start or wait for the end
of the countdown.
Open the water tap.
Contact your local water authority.
Clean the water tap.
Clean the filter.
Make sure that the position of the hose is
correct.
Close the water tap and contact the Serv-
ice.
Clean the sink spigot.
Make sure that the position of the hose is
correct.
If the problem occurs again, contact the Service.
If other alarm codes show, contact the Service.
Clean the filters.
Make sure that the filters are correctly as-
sembled and installed.
Problem
Possible solution
Possible solution
11