Other Programming - Panasonic KX-TGD310NZ Operating Instructions Manual

Programming
7
Edit the phone number if necessary. a
MOKN 2 times
Erasing an outside monitoring
number
1
Press MMENUN on the handset being
monitored.
2
MbN: "On/Off" a MOKN
3
MbN: "On" a MOKN
4
MbN: Select the outside line. a MEDITN
5
MMENUN a MbN: "Erase" a MOKN
6
MbN: "Yes" a MOKN a MOFFN
Baby monitor sensitivity
You can adjust the sensitivity of the baby
monitor. Increase or decrease the sensitivity to
adjust the sound level needed to trigger the
baby monitor feature.
R This feature cannot be set during a
monitoring call.
1
Press MMENUN on the handset being
monitored.
2
MbN: "Sensitivity Level" a MOKN
3
MbN: Select the desired setting. a MOKN
a MOFFN
Answering the baby monitor
n When monitoring with a handset:
Press M N to answer calls.
If you want to respond from the monitoring
handset, press MMUTEN.
R The monitoring handset will answer calls
automatically when the auto intercom
feature is set to "On" (page 17).
Note:
R If you receive an outside call when
communicating with the monitored
handset, the interrupt tone sounds. To
answer the call, press MOFFN, then press
M N.
n When monitoring from an outside line:
Answer the call.
If you want to respond from your monitoring
phone, press #1 using tone dialling.
32
0303_TGD3xxNZ(en-en)_ver002.pdf 32
You can turn off the baby monitor feature
by pressing #0.
Note:
R The unit disconnects the call
automatically after 2 minutes.

Other programming

Changing the handset name
The default handset name is "Handset 1" to
"Handset 6". You can customise the name
of each handset ("Bob", "Kitchen", etc.). This is
useful when you make intercom calls between
handsets. To display the handset name in
standby mode, turn on the handset name
display feature (page 32).
1
MMENUN#104
2
Enter the desired name (10 characters
max.).
3
MOKN a MOFFN
Displaying the handset name
You can select whether or not the handset
name is displayed in standby mode. The
default setting is "Off".
1
MMENUN#105
2
MbN: Select the desired setting. a MOKN
a MOFFN
Storing an area code to be
deleted automatically
In some situations, phone numbers stored
automatically in the caller list (page 36) will
include area codes. If you do not want to dial
the area code when making calls from the
caller list, you can store the area code which
you want the unit to delete automatically.
Example: You have stored the area code
"09". If you make a call from the caller list to
the phone number "09-456-7890", the unit
dials "456-7890".
1
MMENUN#255
2015/03/03 10:28:05