Intercom; Key Lock; Power Backup Operation - Panasonic KX-TGD310NZ Operating Instructions Manual

MMENUN a MbN: "Conference" a
MOKN
R To leave the conference, press MOFFN.
The other 2 parties can continue the
conversation.
R To put the outside call on hold:
MMENUN a MbN: "Hold" a MOKN
To resume the conference: MMENUN
a MbN: "Conference" a MOKN
R To cancel the conference: MMENUN a
MbN: "Stop Conference" a MOKN
You can continue the conversation
with the outside caller.

Intercom

Intercom calls can be made between handsets
in the same radio cell.
Note:
R When paging the handset, the paged
handset beeps for 1 minute.
R If you receive an outside call while talking
on the intercom, the interrupt tone sounds.
To finish intercom, press MOFFN. To answer
the call, press M N.
Making an intercom call
1
M N
When 3 or more handsets are
registered:
MbN: Select the desired unit. a MOKN
2
When you finish talking, press MOFFN.
Answering an intercom call
1
Press M N to answer the page.
2
When you finish talking, press MOFFN.
Turning auto intercom on/off
This feature allows the handset to answer
intercom calls automatically when it is called.
You do not need to press M
feature is set to "On", the monitoring handset
for the baby monitor feature (page 32) will
0303_TGD3xxNZ(en-en)_ver002.pdf 17
also answer baby monitor calls automatically.
The default setting is "Off".
1
MMENUN#273
2
MbN: Select the desired setting. a MOKN
a MOFFN

Key lock

The handset can be locked so that no calls or
settings can be made. Incoming calls can be
answered, but all other functions are disabled
while key lock is on.
To turn key lock on, press MMENUN for about 3
seconds.
R To turn key lock off, press M
3 seconds.
Note:
R Calls to emergency numbers cannot be
made until key lock is turned off.

Power backup operation

When a power failure occurs, the charged
handset temporarily supplies power to the
base unit (power backup mode). This allows
you to make and receive calls using a handset
during a power failure. The base unit will not
perform any other functions. You can program
"Power Failure" and the default setting is
"Auto" (page 26).
Important:
R If a handset is not placed on the base unit
when a power failure occurs, "Base no
power Press OFF" is displayed. After
pressing MOFFN on the handset, place it on
the base unit to start power backup mode.
R Power backup mode will not work if the
battery level of the power supplying
handset is
R Do not lift the power supplying handset
from the base unit during power backup
mode.
N. When this
Making/Answering Calls
N for about
/ .
2015/03/03 10:28:04
17