Connection; Power Cable - Panasonic WV-SW559 Installation Manual

Connection

Caution:
• ONLY CONNECT 12 V DC CLASS 2 POWER SUPPLY (UL 1310/CSA 223) or LIMITED
POWER SOURCE (IEC/EN/UL/CSA 60950-1).
Before starting the connection, turn off the power of this camera and the devices to be connected.
Check and prepare the required devices and cables for connection.
Note:
• When using the mount bracket (accessory), it is possible to connect the cables after mounting
the camera onto the mount bracket.
• Refer to page 19 when connecting the conduit.
z
Connect the microphone/line input cable and the microphone (for use of the audio reception
function).
SW559
Input impedance:
Recommended cable length: Less than 1 m {3.28'} (for microphone input)
Recommended microphone: Plug-in power type microphone (option)
Supply voltage:
Recommended sensitivity of microphone: −48 dB ±3 dB (0 dB=1 V/Pa,1 kHz)
IMPORTANT:
• Connect/disconnect the external speaker cables or audio/video cables after turning off the
power of the camera and the amplifier. Otherwise, loud noise may come out from the speaker.
24
Network cable
RJ-45 (female)
Alarm input/output cable 4P alarm cable (accessory)

Power cable

(12 V DC)
Microphone/line input cable (white)
Audio output cable (black)
2 kΩ±10 %
Less than 10 m {32.8'} (for line input)
Connect a monaural mini plug (ø3.5 mm).
2.5 V ±0.5 V
LAN cable (category 5 or better)
2P power cable (accessory)
SW559
SW559
12 V DC (red)
GND (black)
Power cable
12 V DC
Red Positive
Black Negative