Slant/Fin VSL II series Quick Start Manual page 11

Slant/Fin VSL II Quick Start Guide
Gas input rate
Static gas pressure
Dynamic gas pressure
Gas type
Central Heating supply temperature
Central heating return temperature
CO2 reading at high fire
CO2 reading at low fire
Ionization current
System water pressure
Has the system been properly flushed?
If flushed what agent was used?
Is there an inhibitor in the system?
What inhibitor have been used?
Is there glycol in the system?
What percentage of glcyol?
What brand and type of glycol?
What is the pH of the fluid in the system?
Has the boiler been programmed to match
the heating system it is paired with?
Is the outdoor reset sensor installed?
Is the boiler paired with an indirect tank?
If paired with an indirect tank has a sensor
been installed and wire to the boiler control?
Has the boiler been prgrammed for
DHW operation?
Have all the venting joints been properly
sealed?
Has a CO detector been installed?
Has the piping system been tested for leaks?
Commissioning Check List
btuh
in. W.C.
in. W.C.
F
F
%
%
μA
psi
Yes / No
Yes / No
Yes / No
Yes / No
Yes / No
Yes / No
Yes / No
Yes / No
Yes / No
Yes / No
Yes / No
Yes / No
Yes / No
Yes / No
Yes / No
Yes / No
11