Names Of The Remote Control Parts/Preparing The Remote Control - Mitsubishi DATA PROJECTOR User Manual

Names of the Remote Control Parts/Preparing the Remote Control

STANDBY button [E-21, 23]
This button is used to switch ON the
power and set the unit to the
STANDBY mode.
Buttons used for input selection
[E-26]
RGB button and VIDEO button
(VIDEO / S-VIDEO)
Buttons used for menu operations
[E-37]
The , , and buttons are the
select ( , , and ) buttons.
FREEZE button [E-28]
(Freezes moving pictures)
VOL button [E-28]
(Volume adjustment)
Number buttons [E-34]
(Used for the security lock.)
Note:
If a button on the remote control unit is held in continuously for approximately 30 seconds, signal transfer will be suspended. To resume
transferring signals, press the button again.
Also, to use the jog button after signal transfer has been suspended, first press any other button, then press the jog button.
Inserting the Batteries
When using the remote control for the first time, install the batteries that were supplied.
Slide the battery compartment cover (lo-
1
cated on the bottom of the remote con-
trol) and pull off.
Check the polarity (+), (–) of the batteries,
2
and set them correctly, inserting their (–)
side first.
• If the battery is inserted from the (+) side
first, inserting the (–) side is difficult because
the coil spring end hits on the battery side.
If the battery is forced to insert in this way,
the outer label of the battery may get ripped
and it may cause a short-circuit and heat-
ing.
Caution:
• If the batteries are treated incorrectly, they may cause fire or other contamination due to leakage of the liquid, heating, or they may burst.
(Read the cautions indicated on the battery, too.)
• Do not use a new battery with an old one.
• Load batteries in the correct position.
• Do not heat, take apart, or throw batteries into fire.
• Do not try to racharge batteries. Do not use rechargeable batteries.
• If the solution of batteries comes in contact with your skin or clothes, rinse with water. If the solution comes incontact with your eyes, rinse
them with water and then consult your doctor.
STANDBY
LASER
RGB VIDEO AUTO
MENU QUICK
Q
R-CLICK/
ENTER CANCEL
TIMER
FREEZE MUTE
1 2
VOL ZOOM
3 4
Infrared transmitter [E-13]
Laser transmitter [E-31]
3
E-12
LASER button [E-31]
(Turns the laser point on and off)
AUTO button [E-26]
(Automatic adjustment of the RGB
moving image)
QUICK button [E-36]
(Displays a simplified menu)
Buttons used for the PC mouse
function [E-32]
(JOG button and R-CLICK button)
TIMER button [E-30]
(Presentation timer time setting
display)
MUTE button [E-28]
(Temporarily cancels the video and
audio)
ZOOM button [E-29]
(Digital zoom adjustment)
L-CLICK button [E-32]
(A) Leaving a little space in the front, close
the lid, (B) then with the back pressed
tightly, (C) press the lid towards the front.
* When replacing batteries, purchase two of
the same type of AAA battery.
(A)
(B)
(C)