Using The Remote Control - Mitsubishi XD3500U User Manual

Using the remote control

Operational range of the remote control
Front of projector
30° 30°
• Keep the remote control photo-sensor out of direct
sunlight or fl uorescent lamp light.
• Keep the remote control photo-sensor at least 2 m
(6 feet) away from fl uorescent lamps. Otherwise, the
remote control may malfunction.
• If there is an inverter-operated fl uorescent lamp near
the remote control, the remote control operation may
become unstable.
• When you use the remote control too close to the
remote control sensor, the remote control may not work
correctly.
Reception angle
Vertical directions
Vertical directions (ceiling mount)
Using the wired remote control
Attached remote control for this projector can be used as a wired remote control with remote control cable. Wired
remote control is useful for operating in a distance or outside of the operating area.
Downloaded From projector-manual.com Mitsubishi Manuals
Rear of projector
Operate the remote
control within a distance
of 10 m (30 feet) from the
projector, pointing the
light beam at the remote
control photo-sensor (front
or rear) of the projector.
20°
10°
20°
REMOTE IN
REMOTE OUT
REMOTE IN
30° 30°
When operating the remote control, keep the
distance from the remote control to the projector
via the screen within about 5 m (15 feet). The
operable range of the remote control, however,
depends on the characteristics of the screen.
• For connection, use the pin-pin cable of ø3.5 stereo type,
which is commercially available. However, some cable may
not work correctly.
• When REMOTE OUT terminal on this projector is
connected to the REMOTE IN terminal on the other
projector, the two projectors can be controlled together by
using the remote control.
• When the remote control is connected with remote control
cable, it does not work as a wireless remote control.
• When using the wired remote control, the laser beam may
be darker. It is normal.
• When using the remote control as wired for a long time
period, remove the batteries from it. (Dispose of the
removed batteries according to the cautions on page 6.)
EN-9
20°
10°
20°