Ford f-650 2013 Owner's Manual page 186

Roadside Emergencies
Jump Starting
1. Start the engine of the booster vehicle and run the engine at
moderately increased speed.
2. Start the engine of the disabled vehicle.
3. Once the disabled vehicle has been started, run both engines for an
additional three minutes before disconnecting the jumper cables.
Removing the Jumper Cables
Note: In the illustration, the vehicle on the bottom is used to designate
the assisting (boosting) battery.
Remove the jumper cables in the reverse order that they were
connected.
4
2
After the disabled vehicle has been started and the jumper cables
removed, allow it to idle for several minutes so the engine computer can
relearn its idle conditions.
2013 F-650/750 (f67)
Owners Guide gf, 1st Printing, October 2012
USA (fus)
1. Remove the jumper cable from
the ground metal surface.
2. Remove the jumper cable on the
negative (-) terminal of the
booster vehicle's battery.
3. Remove the jumper cable from
the positive (+) terminal of the
booster vehicle's battery.
4. Remove the jumper cable from
the positive (+) terminal of the
1
disabled vehicle's battery.
3
185