Appendix B: High Definition Inputs Connection Compatibility - Mitsubishi WD-65000 Owner's Manual

Component-1 and Component-2 Inputs
These inputs are compatible with component
video signals from standard DVD players and
other equipment sending a standard NTSC
component video signal (480i). These inputs
may also be compatible with newer DVD
players sending a progressive NTSC compo-
nent video signal (480p).
PC-1 and PC-2 Inputs
This input will accomodate most comput-
ers capable of supporting a VGA, SVGA
or XGA monitor. The only compatible
display sync rate is 60Hz.
DTV Input
This input is compatible with most standard
DTV receivers with component video outputs.
Compatible DTV signals are SDTV 480i,
480p, and HDTV 720P, 1080i.
This input is also compatible with some DTV
receivers using RGB with "sync on green" or
RGB with "separate H and V sync". Compat-
ible DTV signals are SDTV 480i, 480p, and
HDTV 720P, 1080i. Industry standards for
DTV RGB signals systems, synchronization,
timing, and signal strengths are not currently
established. These inputs will not be compat-
ible with all DTV receivers that offer RGB. If
your DTV receiver offers both DTV compo-
nent video signals and DTV RGB signals,
Mitsubishi suggests you use the DTV compo-
nent video signals. Please check the DTV
receiver specifications before connecting.
Appendix B: High Definition Input Connection Compatibility
Input Levels and Timing with Component
Video
Y =1. 0Vp-p (includes sync)75ohms
Cr =700mVp-p, 75ohms
signals from outputs labeled R-Y and Pr)
Cb =700mVp-p, 75ohms
signals from outputs labeled R-Y and Pr)
Input Levels and Timing When Used With
Component Video Signals
EIA -770. 3 Standard Levels and Timing
Y : Vp-p = 1. 0V(includes sync) 75ohms
Pr : Vp-p = 700mV, 75ohms
Pb: Vp-p = 700mV, 75ohms
H : Not Used
V : Not Used
Input Levels and Timing When Used With
RGB Video Signals
G : Vp-p = 1. 0V 75ohms
(Y)
(compatible with sync on green)
R : Vp-p = 700mV, 75ohms
(Pr)
B : Vp-p = 700mV, 75ohms
(Pb)
H : Vp-p = 4V
(when using separate H and V sync)
V : Vp-p = 4V
(when using separate H and V sync)
(can also receive
(can also receive
1. 0V, 75ohms
+/-
1. 0V, 75ohms
+/-
59