Programming The Remote Control: To Activate The System 4 Home Theater Ir Control; To Activate The System 4 Home Theater Ir Control - Mitsubishi WD-65000 Owner's Manual

Part III : Setup
Programming the Remote Control:

To Activate the System 4 Home Theater IR Control

Activation of the System 4 Home Theater
IR Control
For select brands of digital A/V receivers',
you can set up the remote control to auto-
matically select the correct audio input when
you press the HOME THEATER button. At
the same time, the TV will select the correct
video input. This allows you to watch your
best type of video (Component, S-Video)
with your best type of audio (Dolby Digital,
Pro Logic, etc.) conveniently. See System 4
Home Theater IR Control , page 22, for con-
nection instructions.
Once properly activated, when the HOME
THEATER button is pressed, System 4
Operates In 2 Parts:
Changes the TV to the correct input
VIDEO
for the device you wish to operate.
Changes a compatible digital A/V
AUDIO
receiver to the correct input for the device
you wish to operate.
Both functions can operate simultaneously
with one touch of the HOME THEATER
button. However, you may activate only one if
you desire (video to control the TV or
audio to control the A/V Receiver). The re-
mote control must be programmed to the
appropriate A/V Receiver code prior to the
activation of the audio portion (see To Pro-
gram the Remote to Control Other Brands of
Audio and Video Products , page 26).
28
To Activate the Video Portion:
(Figure 1)
Press and hold the HOME THEATER
1
button.
Press and release the VIDEO button.
2
Name the TV input as instructed.
3
HOME
AUDIO
THEATER
1 2
3
Name TV Input as Shown Below
Device You Are Using
Cable Box connected to ANT-A or ANT-B
Satellite Receiver connected to any input
Digital TV/Satellite Receiver connected to DTV
VCR connected to input 1, 2, 3, 4, or 5
DVD connected to any input but DTV
Figure 1. Activating the video portion of System 4
for the CABLE/DBS/DTV layer.
To Activate the Audio Portion:
Press and hold the HOME THEATER
1
button.
Press and release the AUDIO button.
2
(see pg 33 for naming help)
Name Input
Cannot be named
DBS
DTV
VCR
DVD