Installing The Optional Heat-Zone ® Gas Kit - Heat & Glo MEZZO36 Installation Manual

E. Installing the Optional Heat-Zone
Kit
• Locate the Heat-Zone
®
the appliance. See Figure 5.5. Remove the knockouts
from the appliance with a tin snips.
• Place the Heat-Zone
®
the final positioning of the fireplace as shown in Figure
5.5. Secure using eight self-tapping screws. Ensure the
Heat-Zone knockouts are completely covered by the
®
adapter box.
• Center the duct collar around the exposed hole and
attach it to the appliance with 3 screws.
Note: The adapter box will protrude out further than the
one inch standoffs on the appliance.
• Determine the location for the air register/fan housing
assembly.
Reference the Heat-Zone
remaining installation steps.
HEAT ZONE LOCATION
®
LEFT AND RIGHT SIDES
HEAT ZONE ADAPTER BOX
®
Figure 5.5 Heat Zone Adapter
Heat & Glo • MEZZO36/ST, MEZZO48/ST MEZZO60/ST, MEZZO72/ST Installation Manual • 2300-970 Rev. L • 5/15
32
ports on the left and right sides of
adapter box into position prior to
Kit instructions for the
®
Gas
®