Ricoh C226 Service Manual page 233

Assembly:
1. Install the pressure cam drive gear [A].
NOTE: Ensure that the top part of the pressure cam points to the right
[B].
2. Install the relay gear assembly [C].
3. Install the lower support side plate [F].
4. Adjust the drum drive belt position so that the hexagon bolt [G] can be
seen through the hole in the lower support side plate when the drum drive
gear [H] is at drum home position. (The notch cut in the plate [I] lines up
with the gap between the two teeth [J] on the drum drive gear. Also, the
hole [K] in the drum drive gear lines up with a hole in the rear side plate
→ Check by inserting a long screwdriver.)
NOTE: These are the only teeth on the drum drive gear that are not
backed by the metal plate on the rear side of the drum drive gear.
C226
[J]
[K]
[D]
[F]
[E]
[B]
5-60
DRUM SECTION
[I]
[H]
[C]
[A]
[G]
SM