Ricoh C226 Service Manual page 136

Rev. 4/14/97
[D]
[F]
Metal Tab [J]
⇒
[K]
4. Open the ADF unit by pressing the Release lever [K] as shown, then the
non-operation side of the ADF unit with the ADF Lower Rear Cover [E] (1
screw).
NOTE: There is a switch [F] to detect whether the ADF unit is closed.
Make sure that the switch is properly actuated when the ADF unit is
closed after installing the ADF Lower Rear Cover. If not the rib on the ADF
Lower Rear Cover would interfere with the switch [F] if you install the ADF
Lower Rear Cover with the ADF unit closed. The connector [G] is not used
and remains open.
5. Secure the operation side of the ADF unit with the ADF Lower Front
Cover [F] (2 screws). Secure the grounding wire with one of the two
screws.
6. Secure the harness with the two clamps [G].
7. Secure the grounding wire [H] (1 screw).
8. Pass the two harnesses through the cutout in the ADF Lower Rear Cover,
then connect the harnesses to the main body.
9. Install the Connector Cover [I] with the screw [B] removed in step 2.
SM
[E]
[E]
[H]
[G]
3-12
INSTALLATION PROCEDURE
⇒
[I]
A
[G]
[B]
C226