TP-Link TL-MR6400 User Manual page 59

IP Address - The IP Address of the PC providing the service application.

Protocol - The protocol used for this application, either TCP, UDP, or All (all protocols

supported by the router).
Status - The status of this entry, "Enabled" means the virtual server entry is enabled. The

status of this entry is either Enabled or Disabled.
To setup a virtual server entry:
1. Click the Add New... button. (pop-up Figure 4-37)
2. Select the service you want to use from the Common Service Port list. If the Common
Service Port list does not have the service that you want to use, type the number of the
service port or service port range in the Service Port box.
3. Type the IP Address of the computer in the IP Address box.
4. Select the protocol used for this application, either TCP or UDP, or All.
5. Select the Enable check box to enable the virtual server.
6. Click the Save button.

Note
:
It is possible that you have a computer or server that has more than one type of available service.
If so, select another service, and type the same IP address for that computer or server.
To modify an existing entry:
1. Click the Modify in the entry you want to modify.
2. Modify the information.
3. Click the Save button.
Click the Delete in the entry you want to delete to delete an existing entry.
Click the Enable/ Disable All button to make all entries enabled/ disabled.
Click the Delete All button to delete all entries.
TL-MR6400
Figure 4-37 Add or Modify a Virtual Server Entry
300Mbps Wireless N 4G LTE Router
-47-