Telefunken tx-101 User Manual page 69

Answer Only--The pre-set Answer Only outgoing message, where callers hear an announcement
but cannot leave a message,
1. In standby mode, press MENU/OK and then UP/DOWN to select Answering sys.
2. Press MENU/OK then UP/DOWN to select Ans sys setup.
3. Press MENU/OK then UP/DOWN to select Answer mode.
4. Press MENU/OK then UP/DOWN to select Answer & record or Answer only.
5. Press MENU/OK to confirm
Set the answer delay
1. In standby mode, press MENU/OK and then UP/DOWN to select Answering sys.
2. Press MENU/OK then UP/DOWN to select Ans sys setup.
3. Press MENU/OK then UP/DOWN to select # of rings.
4. Press MENU/OK then UP/DOWN to select from 2 rings, 4 rings, 6 rings, 8 rings or Time
saver.
5. Press MENU/OK to confirm.
Note: If Time saver setting is selected, the answering machine will pick up after two rings if there
are new messages and after six rings if there are no messages.
Set recording time of incoming message
1. In standby mode, press MENU/OK and then UP/DOWN to select Answering sys.
2. Press MENU/OK then UP/DOWN to select Ans sys setup.
3. Press MENU/OK then UP/DOWN to select Recording time.
4. Press MENU/OK then UP/DOWN to select recording time from 30 seconds, 60 seconds,
120 seconds and unlimited.
5. Press MENU/OK to confirm.
Set voice language
You can select English or French language for telephone voice prompts.
1. In standby mode, press MENU/OK and then UP/DOWN to select Answering sys.
2. Press MENU/OK then UP/DOWN to select Ans sys setup.
3. Press MENU/OK then UP/DOWN to select Voice language.
4. Press MENU/OK then UP/DOWN to select English or French.
5. Press MENU/OK to confirm.
Call screening
The call screening feature lets you listen at the telephone base to a caller leaving a message.
While monitoring an incoming message, you can answer the call by pressing HOME or SPEAKER
on the handset.
To change the settings
1. In standby mode, press MENU/OK then UP/DOWN to select Answering sys.
2. Press MENU/OK then UP/DOWN to select Ans sys setup.
3. Press MENU/OK then UP/DOWN to select Call screening.
4. Press MENU/OK then UP/DOWN to select On or Off.
5. Press MENU/OK to confirm.
Turn the message alert on/off
When the message alert tone is set to On, the telephone base beeps every 10 seconds to alert
you of new messages. The tone stops when all new messages have been reviewed.
1. In standby mode, MENU/OK then UP/DOWN to select Answering sys.
2. Press MENU/OK then UP/DOWN to select Ans sys setup.
3. Press MENU/OK then UP/DOWN to select Msg alert tone.
4. Press MENU/OK then UP/DOWN to select On or Off.
5. Press MENU/OK to confirm.
TX Bluetooth Guide 69