Setup Headset - AT&T EP5632 User Manual

Bluetooth
NOTE: If you have
a device connected
to the telephone base
when pairing, Connected
devices will be
temporarily disconnected
will appear on the display.
12:00 AM
REDIAL MENU
Main Menu
Call Log
Answering System
Bluetooth
Select
Bluetooth
Set up Cellular
Set up Headset
Active Devices
Select
Set up Headset
Set your Headset
in Discoverable mode,
then press NEXT
Next
Headsets Found
Mary's Headset
FIND PAIR
Set up Headset
Enter PIN:
0000
done help Erase
Headset setup
completed
Set up Headset
Before you begin, make sure that your Bluetooth
enabled headset is not connected to any other
Bluetooth device. Refer to your headset's user's
manual to determine the headset's PIN and how
to set your headset in discoverable mode.
To pair and connect a headset:
1. Using the telephone base, press the
softkey while in idle mode.
Press the UP and DOWN Navkeys to highlight
2. Press the
Bluetooth, then press the SELECT softkey to
enter the Bluetooth menu.
CID
3. Press the UP and DOWN Navkeys to highlight
Set up Headset, then press the SELECT
softkey.
4. Using your headset, set your headset in
discoverable mode.
5. Using the telephone base, press the NEXT
softkey on the telephone base to search for
your headset.
6. Once the telephone base finds your headset,
select it and press the PAIR softkey. If telephone
base cannot find your headset, press the FIND
softkey to search again, and make sure that
your headset is in discoverable mode.
7. Enter the PIN of your headset, then press the DONE
softkey (for most headsets, the PIN is 0000).
INFO
8. When the pairing is complete, press the YES
softkey to connect to your headset.
When a device is connected, the
status icons will appear on the display.
Refer to your headset's user's
• If a device is already connected to the
telephone base, press the OK softkey to
temporarily disconnect the device(s) and
continue the pairing process.
• If successful, Headset setup completed will
appear on the telephone base display.
• If you have already one headset device on the
Active Devices list, press the YES softkey to
connect to your paired headset. You will then
be prompted to replace the existing headset
on the Active Devices list (page 27).
24
press the MENU
to highlight
the 1 and/or 2