Service Miscellaneous - Great Dane Scamper Hydro GLKW1536S Operator's Manual

Service Miscellaneous

Filling Fuel Tank
CAUTION: Avoid injury! Fuel vapors are explosive and
flammable:
•Shut engine off before filling fuel tank.
•Do not smoke while handling fuel.
•Keep fuel away from flames or sparks.
•Fill fuel tank outdoors or in well ventilated area.
•Clean up spilled fuel immediately.
•Use clean approved non-metal container to prevent static
electric discharge.
•Use clean approved plastic funnel without screen or filter
to prevent static electric discharge.
IMPORTANT: Avoid damage! Dirt and water in fuel can cause
engine damage:
• Clean dirt and debris from the fuel tank opening.
• Use clean, fresh, stabilized fuel.
• Fill the fuel tank at the end of each day's operation to keep
condensation out of the fuel tank.
• Use a non-metallic funnel with a plastic mesh strainer when
filling the fuel tank or container.
Fill fuel tank at the end of each day's operation to prevent condensation
and freezing during cold weather.
1.Park machine safely. (See Parking Safely in the SAFETY section.)
2.Allow engine to cool.
3.Remove any trash from area around fuel tank cap.
4.Remove fuel tank cap slowly to allow any pressure built up in tank to
escape.
5.Fill fuel tank only to bottom of filler neck.
6.Install fuel tank cap.
Servicing Caster Wheel Roller Bearings
1.Park machine safely. (See Parking Safely in the Safety section.)
2.Raise and securely support the front of the mower deck.
C
E F
D
SERVICE MISCELLANEOUS
A
B
MX15717
Service Miscellaneous - 20
3.Remove nut (A), bolt (B) and wheel assembly (C).
4.Remove bearing sleeve (D), bearing retainer (E), roller bearing (F) from
wheel.
5.Clean bushing and roller bearing; and pack with clean grease.
6.Install wheel assembly (C), roller bearing (F), bearing retainer (E),
bearing sleeve (D), bolt (B) and nut (A).
Replacing Caster Pivot Bearing Bushings
1.Park machine safely. (See Parking Safely in the Safety section.)
2.Raise and securely support the front of the mower deck.
3.Remove lynch pin (A), spacer bushings (B), washer (C) and caster yoke
and wheel assembly (D).
4.Remove and discard upper (E) and lower (F) bushings.
5.Install new bushings (E and F).
IMPORTANT: Avoid damage! Do not allow washer (C) to set on
caster yoke (D). It must be on top of height-of-cut spacer
bushings (B).
6.Install caster yoke and wheel assembly (D), washer (C), spacer
bushings (B) and lynch pin (A).
7.Apply grease to lubrication fitting (G).
Checking Wheel Nuts
Tighten rear wheel nuts in an alternating pattern to 75 N•m (55 lb-ft).
Troubleshooting
Using Troubleshooting Chart
A
B
E
G
F
C
B
D
MX15717