Service Electrical; Replacing Fuses - Great Dane Scamper Hydro GLKW1536S Operator's Manual

A
B
C
G
H
D
4.Remove pulleys:
• Left Spindle (A): Remove nut (B), pulley (C) and spacer (D).
• Center Spindle (E): Remove nut (F), drive pulley (G) and spindle
pulley (H).
• Right Spindle (I): Remove nut (J), spacer (K) and pulley (L).
5.Remove spindle shaft (M), lower bearing (Q) and spacer (P) from
spindle housing (O). Discard bearing.
6.Remove and discard upper bearing (N).
7.Clean entire assembly.
8.Install a new lower bearing (Q) and spacer (P) on the spindle shaft (M).

SERVICE ELECTRICAL

I
E
F
N
O
P
Q
M
IMPORTANT: Avoid damage! The clearance between the lower
bearing and the housing is only 0.05 mm (0.002 in.). Do not force
bearing into housing.
J
9.Install the spindle shaft (M), lower bearing (Q) and spacer (P) into the
spindle housing (O).
K
10.Install the upper bearing (N).
11.Install upper pulleys:
L
• Left Spindle (A): Install spacer (D), pulley (C) and nut (B). Tighten nut
to 68 N•m (50 lb-ft).
• Center Spindle (E): Install spindle pulley (H), drive pulley (G) and nut
(F). Tighten nut to 68 N•m (50 lb-ft).
• Right Spindle (I): Install pulley (L), spacer (K) and nut (J). Tighten nut
to 68 N•m (50 lb-ft).
12.Install mower blade, blade washers and blade bolt assembly. Tighten
nut to 163 N•m (120 lb-ft).
Replacing Mower Deck Idler Pulleys
1.Park machine safely. (See Parking Safely in the Safety section.)
2.Remove the mower deck drive and spindle drive belts.
3.Remove the mower deck drive tension idler pulley (A) and the mower
and spindle drive tension idler pulley (B).
4.Install new idler pulleys.
5.Install spindle drive and mower deck drive belts.
6.Adjust belt tension.
MX18629
Service Electrical

Replacing Fuses

IMPORTANT: Avoid damage! When replacing fuses - use only 20-
amp fuses or you may damage the circuit.
The machine is equipped with one 20-amp fuse to protect the charging
circuit. These fuses are located under the control panel area.
1.Remove defective fuse from socket.
2.Check metal clip in fuse window and discard fuse if clip is broken.
3.Install new fuse into socket.
Service Electrical - 19
A
B
MX18520