Oki ES5460 User Manual page 40

Colour menu
ITEM
Density Control
Adjust Density
Colour Tuning
C Highlight
C Mid-Tone
C Dark
M Highlight
M Mid-Tone
M Dark
Y Highlight
Y Mid-Tone
Y Dark
K Highlight
K Mid-Tone
K Dark
C Darkness
M Darkness
Y Darkness
K Darkness
Ajst Registration
C Reg Fine Ajst
M Reg Fine Ajst
Y Reg Fine Ajst
Ink Simulation
UCR
CMY 100% Density
CMYK Conversion
CHOICE
AUTO
MANUAL
EXECUTE
PRINT PATTERN
-3~0~+3
-3~0~+3
-3~0~+3
-3~0~+3
-3~0~+3
-3~0~+3
-3~0~+3
-3~0~+3
-3~0~+3
-3~0~+3
-3~0~+3
-3~0~+3
-3~0~+3
-3~0~+3
-3~0~+3
-3~0~+3
EXECUTE
-3~0~+3
-3~0~+3
-3~0~+3
OFF
SWOP
EUROSCALE
JAPAN
LOW
MEDIUM
HIGH
DISABLE
ENABLE
ON/OFF
Configuring your machine.... > 40
DESCRIPTION
If set to AUTO, image density will be automatically
adjusted at power on, when a new image drum or
toner cartridge is installed, and at intervals of 100,
300 and 500 drum counts. If a 500 drum count
interval occurs during a print job it will occur at the
end of that job, and will take up to 55 seconds. If set
to manual, this adjustment will only be performed
when initiated by the next menu item.
Selecting this will perform the auto density set up
immediately.
Selecting this item prints the colour tuning pattern
to help you adjust the colour balance.
Adjusts image density for each colour component
(cyan, magenta, yellow and black). Normal setting is
0.
Adjusts darkness of each colour component (cyan,
magenta, yellow and black). Normal setting is 0.
Performs automatic colour registration adjustment.
Normally this is done on power on and when the top
cover is opened and then closed. This process
accurately aligns the cyan, magenta and yellow
images to the black image.
Performs fine adjustment of image timing in relation
to the black image component.
Selects from a range of industry standard colour
swatches.
Selects limitation to the toner layer thickness.
If paper curl occurs in dark printing, selecting
MEDIUM or LOW sometimes helps reduce this curl.
UCR = Under curl Removal.
When enabled, black areas are produced using
100% C, M, and Y instead of black. This results in a
glossier finish.
Setting to OFF will simplify the conversion process of
CMYK data, which will reduce the processing time.
This setting is ignored when Ink Simulation function
is used.
PS only.