Assembly - Pride Mobility JET 3 ULTRA Owner's Manual

To install the seat:
1. Set the trapeze bars to the desired height. To change
the trapeze bar height, see V. "Comfort Adjustments."
2. Tilt the seat back and slide the rear extrusion onto the
rear trapeze bar. See figure 10.
3. Lower the front extrusion onto the front trapeze bar
until the seat locks into place.
4. Flip the seat latch safety down. See figure 11.
WARNING! Make sure the seat latch
safety is flipped down before using your
power chair.
5. Install the controller into one of the armrests. See V.
"Comfort Adjustments."
6. Turn the rear shroud fasteners one-quarter turn in any
direction. See figure 6.
7. Remove the rear shroud.
8. Plug the motor connectors, the charger inhibit connec-
tor, and the battery connector into the power pod. See
figure 7.
9. Reinstall the rear shroud. Turn the rear shroud fasten-
ers one-quarter turn in any direction.
10. Route the controller cable so that it cannot be pinched
in the seat hinge.
MANDATORY ! P r eve n t c o n t r o l l e r
harness damage! Use correct tie-down
points for controller harness.
11. Secure the controller cable to the armrest receiver with
one or more wire ties.
24
I V . A S S E M B L Y
www.pridemobility.com
SEAT LATCH SAFETY
Figure 11. Seat Latch Safety - Latched
Jet 3 Ultra