Registering A Unit; Additional Handsets - Panasonic KX-TGH223AZ Operating Instructions Manual

– Security is set to "Normal" and
displayed.
– "Security" is not displayed in the
display menu (page 27).
R When enhanced security is enabled, sound
may cut in and out during conversations.
Changing the base unit PIN
Important:
R If you change the PIN (Personal
Identification Number), please make note of
your new PIN. The unit will not reveal the
PIN to you. If you forget your PIN, contact
an authorised service centre.
1
MMENUN (right soft key) #132
2
Enter the current 4-digit base unit PIN
(default: "0000").
3
Enter the new 4-digit base unit PIN. a
MOKN
4
MbN: "Yes" a MOKN a M
Changing the unit's region
setting/Resetting the base unit
1
MMENUN (right soft key) #136
2
MbN: Select the desired country. a MOKN
"Australia" = Australia
"NewZealand" = New Zealand
3
MbN: "Yes" a MOKN a M
Note:
R Changing the unit's region setting may
cause the settings for your country or your
customised settings to return to their default
settings.

Registering a unit

Operating additional units

Additional handsets

Up to 6 handsets can be registered to the
base unit.
TGH222_23AZ(en)_0109_ve001.pdf 35
is
Important:
R The additional handset model
recommended for use with this unit is noted
on page 4. If another handset model is
used, certain operations may not be
available.
Registering a handset to the
base unit
The supplied handset and base unit are
pre-registered. If for some reason the handset
is not registered to the base unit (for example,
is displayed even when the handset is
near the base unit), re-register the handset.
1
Handset:
MMENUN (right soft key) #130
2
Base unit:
Press and hold MLOCATORN for about 5
seconds.
R If all registered handsets start ringing,
N
press MLOCATORN again to stop, then
repeat this step.
3
Handset:
MOKN a Wait until "Base PIN" is
displayed. a Enter the base unit PIN
(default: "0000"). a MOKN
R If you forget your PIN, contact an
authorised service centre.
Deregistering a handset
N
A handset can cancel its own registration to
the base unit, or other handsets registered to
the same base unit. This allows the handset to
end its wireless connection with the system.
1
MMENUN (right soft key) #131
R All handsets registered to the base unit
are displayed.
2
MbN: Select the handset you want to
cancel. a MOKN
3
MbN: "Yes" a MOKN a M
Increasing the range of the base
unit
You can increase the signal range of the base
unit by using a DECT repeater. Please use
Programming
N
35
1/9/2014 10:49:40 AM