Error Messages; Troubleshooting - Panasonic KX-TGH223AZ Operating Instructions Manual

R The following are used for both uppercase and lowercase:
Cyrillic character table (
z 1 2

Error messages

Display message
Base no power
or
No link to base.
Reconnect main
base AC adaptor.
Check
Phone Line
Error
Memory Full
Use
rechargeable
battery.
You must first
subscribe
to Caller ID.

Troubleshooting

If you still have difficulties after following the instructions in this section, disconnect the base unit's
AC adaptor and turn off the handset, then reconnect the base unit's AC adaptor and turn on the
handset.
TGH222_23AZ(en)_0109_ve001.pdf 49
)
3 4 5 6
Cause/solution
R The handset has lost communication with the base unit. Move
closer to the base unit and try again.
R Unplug the base unit's AC adaptor to reset the unit.
Reconnect the adaptor and try again.
R The handset's registration may have been cancelled.
Re-register the handset (page 35).
R The supplied telephone line cord has not been connected yet
or not connected properly. Check the connections (page 9).
R Recording was too short. Try again.
R The phonebook memory is full. Erase unwanted entries
(page 21).
R Message memory is full. Erase unwanted messages
(page 41, 42).
R The call block list memory is full. Erase unwanted entries
(page 31).
R A wrong type of battery such as Alkaline or Manganese was
inserted. Use only the rechargeable Ni-MH batteries noted on
page 3, 6.
R You must subscribe to a Caller ID service. Once you receive
caller information after subscribing to a Caller ID service, this
message will not be displayed.
Useful Information
7 8 9 y
1/9/2014 10:49:40 AM
49