Table of Contents
Advertisement
Programming
MERASEN a MbN: "Yes" a MSELECTN
a MOFFN
Note:
R When editing, press the desired dial key to
add, MCLEARN to erase.
R When viewing, "Block w/o num" is
displayed if the blocking incoming calls
without phone number feature is turned on.
To turn the feature off: MERASEN a MCN
a MSAVEN a MOFFN
Other programming
Changing the handset name
Each handset can be given a customized
name ("Bob", "Kitchen", etc.). This is useful
when you make intercom calls between
handsets. You can also select whether or not
the handset name is displayed in standby
mode. The default setting is "No". If you select
"Yes" without entering any handset name,
"Handset 1" to "Handset 6" is displayed.
1
MMENUN#104
2
Enter the desired name (max. 10
characters; page 17).
3
MSAVEN
4
MbN: Select the desired setting. a
MSELECTN 2 times a MOFFN
Registering a unit
Operating additional units
Additional handsets
Up to 6 handsets can be registered to the
base unit.
Important:
R See page 4 for information on the available
model.
26
TG433CSK_(en_en)_0122_ver011.pdf
Registering a handset to the
base unit
The supplied handset and base unit are
pre-registered. If for some reason the handset
is not registered to the base unit, re-register
the handset.
1
Handset:
MMENUN#130
2
Base unit:
Press and hold MLOCATORN for about 5
seconds.
R If all registered handsets start ringing,
3
Handset:
Press MOKN, then wait until a long beep
sounds.
Deregistering a handset
A handset can cancel its own registration to
the base unit, or other handsets registered to
the same base unit. This allows the handset to
end its wireless connection with the system.
1
MMENUN#131
R All handsets registered to the base unit
2
MbN: Select the handset you want to
cancel. a MSELECTN
3
MbN: "Yes" a MSELECTN a MOFFN
26
press MLOCATORN again to stop, then
repeat this step.
are displayed.
2014/01/22
19:17:40
Advertisement
Table of Contents
