Table of Contents
Advertisement
WI-FI MAINTENANCE AND TROUBlESHOOTING
Wi-Fi connection status
Radio status indicator
Normal Operation .
Wi-Fi signal strength is indicated
by the appropriate number of bars.
The thermostat Wi-Fi settings have not
The frame is displayed and the bars cycle
been entered. Refer to the Wi-Fi Quick
from 0 to 4 .
Start Guide for instructions for entering
the Wi-Fi settings .
The thermostat cannot connect to the
The frame and all bars
Wi-Fi router . Verify that the router is
flash on and off .
functioning properly .
The thermostat cannot connect to
The display will alternate between displaying the
the internet . Verify that your internet
frame and all bars.
connection is working .
There is an internal error with the
The frame will flash on and off .
thermostat Wi-Fi radio . The thermostat will
continue to control the HVAC and indoor
air quality control equipment, but will not
be able to connect to Wi-Fi. contact an
HVAC professional for repair .
Wi-Fi radio turned off . Refer to the Setup
Not displayed .
Menu section for information about turning
the Wi-Fi module on .
32
SETUP MENU
HOW TO ENTER THE SETUP MENU TO CHANGE SETTINGS
Message Center
No corresponding message
Press [MENU] to enter the main menu .
Press [SETUP] to enter the setup menu .
Displays the SSID of the
thermostat . Note: The SSID
will be used to identify the
thermostat when using a
smart device to connect the
thermostat to your Wi-Fi router .
WiFi Connection Lost
Press [Next] or [Back] to page through the settings
Internet Connection Lost
(the setting is displayed in the message center) .
Radio Error
WiFi Turned Off
Press
or
to adjust the setting. (selected option
flashes .)
Press [DONE] to save and exit, Or [CANCEl] to exit
without saving .
The thermostat will discard changes and exit if nothing
is pressed within 60 seconds .
MESSAGE CENTER
(SCROLLING TEXT)
33
Hide quick links:
Advertisement
Table of Contents
