Memory - Storage And Recall Of The Last 90 Measurements; Memory - Cancellation Of All Measurements - ReliOn BP200W Instruction Manual

The traffic light bar raises according to your measurement.
• If the bar is in the green zone, your measurement is "Normal" accord-
ing to NIH standards
• If the bars are in the yellow zone, your measurement is "Pre-Hyperten-
sion" according to NIH standards
• If the bars are in the orange zone, it is "Stage 1 Hypertension"
• If the bars are in the red zone, it is "Stage 2 Hypertension"
5.8. Memory – storage and recall of the measurements
With the unit OFF, press and hold the MEMORY button. The screen will
show "A" followed by an average of all stored readings. The "M" symbol
is displayed in the lower left. Each time you press the memory button an
earlier measurement will be displayed along with time and date.
When the memory has stored 90 results a new measured value is stored
by overwriting the oldest value.
5.9. Memory – cancellation of all measurements
Attention!
Before proceeding to clear all the memory, make sure
that you don't have to make reference to the readings
in the future.
If you are sure that you want to permanently remove all
stored values, hold down the "M" button (the instru-
ment must have been switched off beforehand) until
"CL" appears and then release the button. If you do not
want to clear the values, press the ON/OFF button. To
permanently clear the memory, press the "M" button
while "CL" is flashing.
Individual values cannot be cleared.
13