Before Using The Unit; Setting The Line Mode - Sony PDW-D1 Operation Manual

Before Using the
Unit

Setting the Line Mode

This unit is shipped with the line mode still
unset. Therefore you need to set the line
mode before using the unit. (The unit
cannot be used unless the line mode is set.)
Once it is set, the line mode is retained even
when the unit is powered off.
Setting procedure
Use the following procedure to set the line
mode.
1
Power the unit on (see page 96).
2
Start the utility software (see page
119).
In the Line mode box of the Basic
information screen, "----" appears.
For details of installation of the utility
software, see "Utility software" (page 99).
For details of the utility software, see Chapter
5, "Using the Utility Software" (page 119).
3
In the tree display, select "Setup" -
"AV settings."
Menu item "525/625 SYSTEM
SELECT" appears in the operating
screen.
4
Using the V/v buttons or the up and
down arrow keys on the keyboard,
select "525" or "625."
Setting Line mode
525 525: NTSC
625 625: PAL
5
Click the Set button.
"Turn off/on POWER!" appears.
6
On a Macintosh computer, click the
"Change Connection" button to switch
to "AVc/Log out."
7
Exit the utility software (see page
120).
8
Power the unit off, and then power it
on again.
The selected line mode becomes
available for use.
You can change the setting made with this
procedure by using setup menu item "AV
settings" - "525/625 SYSTEM SELECT." See
5-3-2 "Setup Menu" (page 124) for more
information about how to make setup menu
settings.
Note
The line mode is not set, or is cleared, in the
following situation. Reset the line mode.
• The unit is powered off before
performing step 6 in the previous
procedure.

Before Using the Unit

85