Mazda 121 Workshop Manual page 381

TRANSAXLE
J
1. Engine mount No.2
2. Iransaxle
lnstallation Note........
page J-57
3. Stittner
4. Exhaust pipe bracket
5. Engine mount member
installationNote........
pageJ-57
6. Staner
7. Driveshatt
Installation Note..........................
page J-58
8. Control rod
lnstallation Note ..........................
page J-58
9. Extension bar
lnstallation Note..........................
page J-58
10. Neutral switch connector
11. Back-up light switch connector
'12. Clutch cable
lnstallatlon Note..........................
page J-58
11
qno6.l^mal6r
^.h16
lnstallation Note..........................
page J-58
14. Battery, battery carrier
15. Splash shied
16. Wheel and trre
Installation Note
Transaxle
1. Set the transaxle on a jack and lift it into place.
2. lnstall lhe transaxle bolts.
Tightening lorque
A: 64-89 N.m (6.5-9.1
Bt 7.3-11 N.m (0.8-l.l
m-kg, 47-66 ft-lb)
n-kg, 5.8-8.0 ft-lb)
Engine mount member
1. Install the bolts and nuts as shown.
Tightenlng torque
@: 64-89 N.m (6.5-9.1 m-kg, 47-66 ft-lb)
@: 37-52 N.m (3.8-5.3 m-kg, 28-38 ft-lb)
Caution
. BetoF install the engine mount member, pul engine
mount No.1 and No.2 studs in the installlng hole.
2. Remove the SST (Eqine support).
@rj&{r@
J-57