Mazda 121 Workshop Manual page 366

J
TRANSAXLE
6. Set the SST (collals) between the transaxle case and clutch
housing in the positions shown in the figure.
7. Tighten the SST (bolt set) io the specjfied torque
Tiqhtenlnq torque:
ls-ze-Nm (i.9-2.6 m-kg, 14-19 fi'lb)
Note
. Turn the bars until the SST (seleclor) no longer
iurns,
8. Mountthe bars on parts @ and @ of the selector, and turn
the selsctor so the gap is widened.
9. Turn in the reverse direction until the gap is eliminated.
01EoJX,115
10. Install the SST to the difterential pinion shaft through the
transaxle case.
J-42