Mazda 121 Workshop Manual page 368

J
TRANSAXLE
01E0JX-121
20. Measure the preload as follows. Set the differential assem-
bly into the clutch housing.
21. lnstall the kansaxle case onto the clutch housing
Tlght€ning torque:
t9-26 N.m (1.9-2.6 m-kg, 14-19 ft-lb)
22. Install the SST to the differential side gear through the trans-
axle case.
Note
. Procadurc 23 work wilh a pull scale'
. Prccedure 24 work with a iorque wrsnch.
23. Turn the SST (preload anachmet ) with a pull scale
Readjust the SST (prsload adaptor) until the specified
preload when not apply.
Preload: 0,5-0.7 Nm (5-7.6 cm-kg, 4'3-6.6 innb)
Pull scale: 500-760 g (17.7-26'8 oz)
24. Turn the SST with a torque wrench.
Readjust lhe SST (Preload adaptor) until the specified
preload when not aPPlY.
Pleload: 0.5-0.7 l,l'rn (5-7.6 cm-kg, 4.3-6'6 in'lb)
25. Remove the SST.
26. Remove the transaxle case and then the ditferential as-
semory.
!:1
t/
@
J-44