Panasonic WJ-SX650 Series Operating Instructions Manual page 32

Notes:
• When changing connections, perform the LCN settings of camera input channels supplying video input signals to
recorders. The LCN settings are performed in "System" – "Recorder" – "LCN setting".
• Camera input signals are looped through the unit. Monitor display information (camera title, etc.) are not recorded.
Video input signals are supplied from
recorders to the CAMERA IN 31 and 32.
32 31 30
Unit Address (System): 2
Do not connect VIDEO OUT of the unit to camera input connectors of recorders
if these camera input channels supply video output signals from recorders.
Note: Do not connect the VIDEO OUT ports of the unit to the camera input connectors of recorders if these camera input chan-
nels supply video output signals from recorders.
G Connection between Recorders and Video Input Boards
By connecting recorders to the DATA ports of this unit, recorder control becomes available from system controllers.
Recorder number (Unit Address (System))
1 to 4
5 to 8
9 to 12
13 to 16
Note: You can change data port settings according to the connected devices. Setting changes are performed in "System" –
"DATA Port" of WJ-SX650 Series Administrator Console or DATA PORT (refer to p. 53) of SETUP MENU.
32
EXTENSION 3 IN EXTENSION 2 IN
VIDEO OUT 4 VIDEO OUT 3
32 31 30 29 28 27
16 15 14 13 12 11
25 24 17 16
Recorder
LCN: 17 to 32
DATA port for recorder connection
DATA 3 port of Video Output Board 1
(Factory default: HDR1)
DATA 4 port of Video Output Board 1
(Factory default: HDR2)
DATA 3 port of Video Output Board 2
(Factory default: HDR3)
DATA 4 port of Video Output Board 2
(Factory default: HDR4)
4 3
RS485 (CAMERA)
MODE MODE MODE
VIDEO OUT 2 VIDEO OUT 1
26 25 24 23 22
10 9 8 7 6
CAMERA IN
9 8 1
Recorder
LCN: 1 to 16
Unit Address (System): 1
2 1
RS485 (CAMERA)
MODE IN C-3
ALARM IN IN X-2
21 20 19 18 17
5 4 3 2 1
IN X-1
D-sub/BNC Video Cable WJ-CA68
BNC cable
Video input
board