Gateway E-4620 Reference Manual page 57

www.gateway.com
5
Pull open the card retention lever.
6
If you are replacing an expansion card, remove the old
card. You can slightly seesaw the card end-to-end to
loosen the card, but do not bend the card sideways.
Caution
Do not touch the contacts on the bottom part of the expansion
card. Touching the contacts can cause electrostatic damage to the card.
7
If you are installing a new expansion card, remove the
EMI shield from the opening near the expansion slot.
8
Install the new card into the expansion slot. You can
slightly seesaw the card end-to-end to help insert the
card, but do not bend the card sideways.
9
Press the card retention lever back into place.
10
If you have just replaced an expansion card, reconnect
the expansion card cables (if any) using the notes you
took previously.
- OR -
If you have added a new expansion card, connect its
cables according to its user guide.
11
Replace the front bezel, replace the hard drive bracket,
then replace the side panel.
Card retention lever
51