Step 1. Fitting The Dishwasher In Place - Asko D5534XLFI Installation Instructions Manual

STEP 1. FITTING THE DISHWASHER IN PLACE

1. Be sure to remove the transport protection for the
door when unpacking the dishwasher.
2. Attach the light shielding film (packed in the
document bag) to the underside of the countertop
above the touch buttons. (Only certain models).
The light shielding film ensures optimal button
!
functionality.
NOTE:
The surface on which the protective film is to be
attached must be clean and dry.
3. Attach the supplied door sealing
(only certain models).
This strip is an essential part of the Turbo Dry
Express system and must be installed to ensure
an optimum seal between the dishwasher tank
and door.
4. Start by measuring the height from the floor to the
bottom edge of the counter top. Measure the height
from the floor to the top edge of the dishwasher.
5. Push the plastic feet into place on all steel feet
(included in document bag). (Only certain models.)
NOTE:
Do not attach the plastic feet if the installation
space is too tight.
461326 Install DW90 FI USA EN Rev 01.indd 7
2x
1
2
Customer Care Center
1-800-898-1879
www.askona.com
1
2
3
Page 7
2014-01-16 10:51:34